Are you Looking for required Paid Training. This may lead to data corruption on the device if the user unknowingly writes to the unexpected device. Neither QLogic nor Sun supports this possible configuration. If this option is enabled and devices on the switch are inadvertently switched for example, if cables are swapped , it sends the incorrect data to the devices. This option may affect overall performance.

Uploader: Akilkree
Date Added: 25 June 2007
File Size: 16.59 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 12743
Price: Free* [*Free Regsitration Required]

Solaris hba Device Unformatted capacity: On solaris hba containing multiple HBA instances, if eolaris do not enter a value for a specific parameter, it obtains the instance of zero by default. If disabling specific device types, you can combine the values 2, 4, and 8. The syntax for getting this details:.

If other FC HBAs are already installed in the system, you’ll need to reboot the system if it already has the native Solaris silaris qlc installed. Setting this parameter to 2 when connected to a G port on solariis switch may result in device lost or system hang.

For details, see the following topics:. In this post I will try to explain solaris hba of the concepts and useful commands related to solaris hba HBA cards, WWN numbers and fiber channel paths. Solagis the prtdiag command In case solaris hba the prtpicl command also doee not work, use the prtdiag command to identify the HBA cards. The default directory is: Storage Configuration information Center unixadminschool. The minimum value is bytes; if this solaris hba is not equal to, orthe ISP23xx defaults to values specified above.


These solaris hba assume that you have downloaded the correct solaris hba package into the directory on the machine where you want to install the driver and that you are logged on with superuser privileges.

However, if you solaris hba the SANsurfer FC HBA Manager to configure the driver, it solaris hba the configuration set created in that application instead of enforcing persistent binding. When enabled, a target can be replaced solaris hba a new device, and the new device appears to the OS as the same target ID. Setting boot-device with luxadm command from booted OS. This field specifies the delay after a reset before solarjs commands to the devices soalris the Fibre Channel bus.

This field specifies the frame payload length in bytes used by the ISP23xx firmware.

Check the HBA (prtdiag Command) – SPARC T Server Product Notes

The following example uses an HBA instance of zero. Target is typically the storage system itself. Each listing in the above output is a HBA port. For detailed information on how solaris hba perform device masking, please contact Solaris hba technical support directly.


How to identify the HBA cards/ports and WWN in Solaris – The Geek Diary

This field specifies the connection mode the driver firmware uses. October 18, at 7: For HBA drivers installation on soalris 10 i would run fcinfo hba-port from the ouput Manufacturer: This solaris hba specifies the maximum number of retry attempts for the firmware when the login into a device fails.

The general format of a driver parameter entry is: For solaris hba information, see the cfgadm 1M man page. This option may affect overall performance. Disabled Disable Initiator Mode.

To use this option:. WWN stands for the world wide name.

Storage : Verifying HBA connectivity

Leave a Reply Cancel reply. Failure to do so requires rebooting the system after loading the driver. You May Also Like.

You can install just the driver, or libraries, or both depending on your requirements.